1996 Land Rover Defender Worshop Manual 300 Tdi

ENGINE
OIL FILTER
OIL TEMPERATURE CONTROL VALVE
Service repair no - 12.60.69
Remove
Service repair no - 12.60.01
Remove
1.
2.
Place drain tray under oil filter.
Unscrew filter anti-clockwise, using a strap
wrench, if necessary.
1.  Clean adaptor housing.
2.  Disconnect oil cooler feed pipe from thermostat
extension housing and plug to prevent ingress of
dirt.
3.
Remove 2 bolts and carefully withdraw
thermostat extension housing (1) complete with
’O’ ring seal (2), thermostat (3), 2 washers (4)
and spring (5).
Refit
4.  Inspect all parts and renew as necessary.
3.
4.
Clean mating face of oil filter adaptor.
Coat rubber sealing ring of new filter with clean
engine oil.
Refit
5.  Fit thermostat to extension housing ensuring pin
locates in hole.
6.  Fit two washers and spring to thermostat.
7.  Fit a new ’O’ ring to extension housing.
5.
Screw on filter until sealing ring touches
machined face, then tighten a further half turn by
hand only. DO NOT over tighten.
8.
Insert spring into adaptor and secure extension
housing to adaptor. Tighten bolts to 9 Nm (7
lbf/ft).
REPAIR
19
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field