1996 Land Rover Defender Worshop Manual 300 Tdi

STEERING
Fitting sector shaft cover
73.
Fit new sealing ring to cover.
74.
75.
Align cover with casing.
Screw cover assembly fully on to sector shaft
adjuster screw.
76.
If necessary back off sector shaft adjuster screw.
Tap cover in place to allow cover to joint fully
with casing.
NOTE: Before tightening fixings, rotate
input shaft to ensure sector shaft roller is
free to move in valve worm. If initial
resistance is left, turn adjuster screw
approximately two turns in a clockwise direction.
81.
To set worm on centre, rotate input shaft to full
inner-lock (full right lock for a left hand drive
vehicle, full left lock for a right hand drive
vehicle). Rotate input shaft back towards centre
two full turns.
The box is now on centre and can be adjusted.
Hold input shaft and rock drop arm to establish
backlash is present. Continue rocking and slowly
turn sector shaft adjusting screw clockwise.
Continue rotating adjuster screw until backlash
has almost been eliminated.
77.
Fit cover bolts. Tighten to75 Nm (55 lbf/ft).
Fitting cylinder cover
78.
79.
Fit new square section seal to cover.
Remove slave bolt fitted at instruction 68. Press
cover into cylinder just to clear retainer ring
groove.
Fit retaining ring to groove with one end of ring
positioned 12 mm from extractor hole.
82.
83.
80.
Adjusting sector shaft
NOTE: Refit drop arm and tighten nut
sufficiently to ensure that no backlash
exists between drop arm and sector shaft.
OVERHAUL
7
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field