1996 Land Rover Defender Worshop Manual 300 Tdi

47
PROPELLER SHAFTS
Assembly
21.  Fit grease nipples to spider and sliding member.
22.
Apply instructions 14 to 19 to opposite end of
propeller shaft.
11.
12.
Remove bearing cups from new spider.
Check all needle rollers are present and
positioned in bearing cups.
23.  Fit grease nipple and lubricate.
13.
Ensure bearing cups are one-third full of
lubricant  See LUBRICANTS, FLUIDS AND
CAPACITIES, Information,  Recommended
lubricants and fluids .
Enter new spider with seals into yokes of sliding
member flange.
Partially insert one bearing cup into flange yoke
and enter spider trunnion into bearing cup.
Insert opposite bearing cup into flange yoke.
Press both cups into place.
Refit
24.  Fit propeller shafts to vehicle with sliding joints to
transfer box and tighten nuts to 47 Nm (35
lbf/ft).
14.
15.
16.
17.
18.
19.
Press each cup into its respective yoke up to
lower land of circlip grooves. Damage may be
caused to cups and seals if cups pass this point.
Fit circlips and check no end float exists.
20.
Engage spider in yokes of sliding member. Fit
bearing cups and circlips as described in
instructions 14 to 19.
2
REPAIR
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field