ENGINE
FRONT COVER GASKET
Service repair no - 12.65.10
Remove
15. Secure with bolts of correct length in locations
where slave studs are not fitted, see J6149.
16. Remove slave studs and fit correct length bolts.
17.
Tighten all bolts to 25 Nm (18 lbf/ft).
1.
Remove camshaft drive belt. See Camshaft
drive belt
2.
3.
4.
Remove crankshaft gear. See Crankshaft gear
Remove camshaft gear. See Camshaft gear
Remove injection pump gear. See Injection
pump gear
5.
6.
Remove fuel injection pump. See FUEL
SYSTEM, Repair, Fuel injection pump
Remove engine oil sump. See Engine oil
sump
7.
Remove oil pick up strainer. See Oil pick-up
strainer
8.
Remove 10 bolts securing timing gear housing to
block.
9.
Withdraw timing gear housing complete with
gasket.
10.
Clean all gasket material from mating faces.
1
- 25 mm, 2 - 35 mm, 3 - 80 mm.
18.
Fit oil pick-up strainer. See Oil pick-up
strainer
19.
20.
Fit oil sump. See Engine oil sump
Fit fuel injection pump. See FUEL SYSTEM,
Repair, Fuel injection pump
Fit injection pump gear. See Injection pump
gear
21.
22.
23.
24.
Fit camshaft gear. See Camshaft gear
Fit crankshaft gear. See Crankshaft gear
Fit camshaft drive belt. See Camshaft drive
belt
Refit
11.
12.
13.
14.
Fit slave guide studs to locate gasket.
Fit new gasket to cylinder block.
Align flats on oil pump with flats on crankshaft.
Fit front cover to block taking care not to damage
oil seal.
REPAIR
13
Product Specification
Categories | Land Rover, Land Rover Defender |
---|---|
Tags | Land Rover |
Model Year | 1996 |
Download File |
|
Document Type | Workshop Manual |
Language | English |
Product Name | Defender 300 Tdi |
Product Brand | Land Rover |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |