HEATING AND VENTILATION
Refit
14.
CONTROL CABLE AND BLOWER MOTOR SWITCH
Fit new control cable through heater duct cover
and secure to vent flap trunnion. Bend over
cable end to fully secure.
Service repair no - 80.10.17 - Control cable
Service repair no - 80.10.22 - Blower motor switch
15.
16.
Fit heater duct cover.
Remove
Fit lower fascia panel assembly to fascia
bulkhead See CHASSIS AND BODY, Repair,
lower fascia panel (heater duct) assembly.
Route control cable along fascia bulkhead to
contol lever assembly.
1. Disconnect battery.
17.
18.
With control lever in closed position, secure
cable to clevis.
19.
20.
Fit outer cable retaining clip to lever assembly.
Fit lever assembly to side cover. Ensure screw
spacers are fitted between cover and lever
assembly.
21.
22.
23.
Fit side cover to fascia cowl.
Fit control lever knobs.
Fit instrument panel See INSTRUMENTS,
Repair, Instrument panel.
24.
Fit steering column nacelle See STEERING,
Repair, Steering column nacelle.
2.
3.
4.
From inside engine compartment, release outer
cable retaining clip at heater unit.
Slacken trunnion fixing and release inner cable
from heater unit flap lever.
Release 2 retaining clips securing control cables
to engine bulkhead and heater hoses.
5.
6.
Remove 4 screws securing instrument panel to
fascia cowl.
Pull instrument panel away from fascia and
disconnect speedometer cable to ease access to
control cable.
7.
Remove 2 screws securing control lever
assembly to side of fascia panel cowl. Note
plastic screw spacers fitted between cowl and
lever assembly and retain.
REPAIR
7
Product Specification
Categories | Land Rover, Land Rover Defender |
---|---|
Tags | Land Rover |
Model Year | 1996 |
Download File |
|
Document Type | Workshop Manual |
Language | English |
Product Name | Defender 300 Tdi |
Product Brand | Land Rover |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |