86
ELECTRICAL
HEADLAMP BEAM ALIGNMENT
Service repair no - 86.40.17
Check
On vehicles fitted with headlamp levelling units, check
and adjust headlamp beam alignment as previously
described, with fascia mounted levelling switch at
position ’0’. The headlamps can then be adjusted,
according to load conditions, as follows:-
Check main beam alignment using beam setting
equipment. Should this not be available the beam can
be temporarily checked and adjusted as follows:-
1.
Position vehicle, unladen, on level ground with
tyres correctly inflated, approximately 4 meters
from a wall or screen, marked as illustrated
below.
Position ’0’ - Driver only, or driver and all front seats
occupied (loadspace empty).
Position ’1’ - All seats occupied (loadspace empty).
2.
The beam centres ’A’ are measured horizontally
on the vehicle and dimension ’B’ vertically from
the ground.
Position ’2’ - All seats occupied by adults and
loadspace loaded to maximum rear axle weight.
Position ’3’ - Driver only with loadspace loaded to
maximum rear axle weight.
3.
Switch on main beam and adjust setting, as
necessary, with trimmer screws.
24
REPAIR
| Categories | Land Rover, Land Rover Defender |
|---|---|
| Tags | Land Rover |
| Model Year | 1996 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Defender 300 Tdi |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)