1996 Land Rover Defender Worshop Manual 300 Tdi

MANUAL GEARBOX
Separating transfer gearbox from main gearbox
50.
Remove transmission assembly from hoist
cradle and position safely on a bench.
63.
64.
Fit link to differential lock lever and secure with 2
clips
Align lever to high/low shaft, position washer, fit
bolt and new Nyloc nut. Tighten to 2 Nm (1.5
lbf/ft).
65.
Position breather pipes, secure pipe unions
using new sealing washers. Tighten unions to 15
Nm (11 lbf/ft).
51.
52.
Remove breather pipes. Discard pipe union
sealing washers.
Remove ’Nyloc’ nut, and remove bolt, securing
lever to high/low shaft.
Collect spacer washer.
Remove 2 clips and remove differential lock
lever link.
Remove lower locknut from high/low operating
rod.
Place a sling round transfer box and attach to
hoist.
Remove nut and 4 bolts securing transfer
gearbox to extension housing.
Withdraw transfer gearbox.
Fitting transfer gearbox and main gearbox
assembly
66.
67.
Position transmission assembly to hoist cradle.
Clean bell housing and engine mating faces.
Apply sealant to both mating faces.
53.
54.
68.
69.
70.
Temporarily fit gear lever and select any gear in
main gearbox to facilitate entry of gearbox input
shaft. Engage low range.
Position and raise hoist, fit transmission to
engine whilst keeping harness and pipes clear to
prevent trapping.
55.
56.
57.
58.
Secure transmission to engine. Tighten fixings to
45
Nm (33 lbf/ft).
71.
72.
Secure earth leads to RH side of transfer box.
Connect reverse lamp switch connectors and
differential lock switch connectors.
Secure breather pipes to harness with clips.
Remove support from engine sump.
Position temporary support under transmission.
Secure LH and RH mounting brackets to
gearbox. Tighten fixings to 55 Nm (41 lbf/ft).
With assistance and using a body jack between
chassis longitudinals, jack chassis sufficiently to
enable fitment of crossmember.
Assembling transfer gearbox to main gearbox
59.
60.
61.
62.
Clean extension housing and transfer gearbox
mating faces.
Ensuring loose upper dowel is fitted, hoist
transfer gearbox into position.
Secure transfer box to extension housing.
Tighten fixings to 40 Nm (30 lbf/ft).
Connect high/low operating rod, fit and tighten
locknut.
73.
74.
75.
76.
77.
REPAIR
5
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field