1996 Land Rover Defender Worshop Manual 300 Tdi

12
ENGINE
Refit
CAMSHAFT DRIVE BELT
Service repair no - 12.65.18
Remove
14.
15.
Fit gasket to centre bolt boss.
Locate new gasket and fit front cover plate using
fixing bolts as shown. Tighten bolts to 25 Nm (18
lbf/ft).
1.
2.
Remove front cover plate. See  Front cover
plate
Position engine at TDC on No. 1 cylinder.
3.
4.
Remove blanking plug from flywheel housing
and insert timing tool LRT-12-044.
Engage timing tool pin with slot in flywheel.
1
- 25 mm, 2 - 35 mm, 3 - 50 mm, 4 - 100 mm, 5 - 110
mm
16.
17.
Fit crankshaft pulley.  See Crankshaft pulley
Fit drive belt.  See ELECTRICAL, Repair,
Auxiliary drive belt
18.
19.
Fit fan cowl.  See COOLING SYSTEM, Repair,
Fan cowl
Fit viscous coupling and fan. See COOLING
SYSTEM, Repair,  Viscous coupling and fan
Fit intercooler to induction manifold hose.
Fit top hose to radiator.
Refill cooling system.  See COOLING SYSTEM,
Repair,  Drain and refill cooling system
Reconnect battery.
20.
21.
22.
23.
5.
6.
Check correct alignment of timing mark on
camshaft gear and that crankshaft key aligns
with cast arrow on housing.
Insert pin from special tool LRT-12-045 in
injection pump gear and through into pump
flange.
8
REPAIR
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field