1996 Land Rover Defender Worshop Manual 300 Tdi

TRANSFER GEARBOX
TRANSFER GEARBOX
Service repair no - 41.20.25
Remove
The transfer gearbox should be removed from
underneath the vehicle, using a hydraulic hoist and
adaptor plate LRT-99-010.
6.
7.
8.
Remove 4 screws securing centre access panel
to seat or cubby box base.
Release EGR and alarm system diagnostic
connector mounting bracket.
Lift up access panel, complete with diagnostic
connector harness, and place aside.
WARNING: Where use of a transmission
hoist is necessary, it is absolutely
essential to follow the manufacturers’
instructions to ensure safe and effective use of
the equipment.
NOTE: A chassis undertray may be fitted
on some vehicle derivatives to conform to
legal requirements. When under chassis
remove and refit procedures are required, it may
be necessary to remove the undertray See
CHASSIS AND BODY, Repair, Front undertray or
See CHASSIS AND BODY, Repair, Rear undertray
.
1.
2.
Position vehicle on a ramp.
Select LOW range gear and leave vehicle in
neutral.
3.
4.
Disconnect battery.
Remove front, centre, seat cushion, or cubby
box  See CHASSIS AND BODY, Repair,
Cubby box .
If fitted, disconnect multi-plug from EGR control
unit located on base of seat cushion or cubby
box.
9.  Remove breather pipe union from transfer
gearbox high/low cross-shaft housing.
10.  Remove retaining clip and disconnect high/low
lever from operating rod.
5.
REPAIR
1
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field