30
MANIFOLD AND EXHAUST SYSTEM
Refit
EXHAUST MANIFOLD/TURBOCHARGER
ASSEMBLY
11.
12.
Fit new gasket over manifold studs.
Loosely fit induction manifold lower nuts to
studs.
Fit exhaust manifold and secure with central
upper and lower nuts.
Locate heater rail to its correct position and
secure with outer exhaust manifold nuts.
Tighten all exhaust manifold nuts to 45 Nm (33
lbf/ft).
Tighten exhaust front pipe to intermediate
silencer nuts to 50 Nm (37 lbf/ft).
Fit turbocharger outlet pipe.
Service repair no - 30.15.10
Remove
13.
14.
15.
16.
1. Remove induction manifold See Induction
manifold .
2. Disconnect turbocharger inlet hose.
3. Disconnect boost pressure pipe at turbocharger.
17.
18.
Fit induction manifold See Induction manifold
.
4.
5.
Remove intercooler bottom hose.
Place suitable container under engine and
disconnect turbocharger oil feed and return
pipes at cylinder block.
6.
7.
Remove 3 nuts securing exhaust front pipe to
manifold flange.
Remove 7 nuts and lift exhaust manifold and
turbocharger assembly from cylinder head.
Discard manifold gasket.
8.
Refit
9.
Fit new manifold gasket.
10.
Position exhaust manifold assembly onto
location studs and secure to cylinder head.
Tighten nuts to 45 Nm (33 lbf/ft).
Secure exhaust front pipe to manifold flange.
Tighten fixings to 50 Nm (37 lbf/ft).
Reconnect turbocharger oil feed and return
pipes at cylinder block.
11.
12.
13.
14.
15.
16.
Fit intercooler bottom hose.
Fit boost pressure pipe at turbocharger.
Fit turbocharger inlet hose.
Fit induction manifold See Induction manifold
.
2
REPAIR
| Categories | Land Rover, Land Rover Defender |
|---|---|
| Tags | Land Rover |
| Model Year | 1996 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Defender 300 Tdi |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)