1996 Land Rover Defender Worshop Manual 300 Tdi

ENGINE
30.
Using suitable hoist, fit chains to lifting brackets
and support engine.
31.
Remove nuts and plain washers securing front
engine mountings to chassis.
26.
27.
Disconnect both pipes from fuel lift pump.
Release fuel feed pipe from retaining clip on air
cleaner bracket.
32.
33.
Support gearbox.
Remove engine to bell housing fixings, leaving
starter motor attached to engine.
Carefully raise engine to release from gearbox.
Ensure all relevant connections to engine have
been removed.
34.
35.
28.
Disconnect vacuum hose from brake servo.
36.
Remove engine.
Refit
37.
38.
Clean bell housing.
Apply Hylomar sealant to mating faces of bell
housing and flywheel housing.
Lubricate splines of gearbox primary pinion with
Rocol MV 3.
Carefully lower engine into position and locate
primary pinion into clutch and engage bell
housing dowels.
39.
40.
41.
Fit engine to bell housing fixings. Tighten to 40
Nm (30 lbf/ft).
29.
Remove oil pipes from oil filter adaptor.
REPAIR
5
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field