1996 Land Rover Defender Worshop Manual 300 Tdi

57
STEERING
67.
Back off worm adjuster 1/4 turn. Turn in worm
adjuster to increase reading by 0.21 - 0.34 Nm
with locknut tight, 100 Nm (74 lbf/ft). Use worm
adjusting wrench LRT-57-006and locknut
wrench LRT-57-028.
61.
Fit new worm adjuster sealing ring.
Fitting rack and piston
68.
69.
Screw slave bolt into piston to aid assembly.
Fit piston and rack so piston is 70 mm (2.75 in)
from outer end of bore.
Fitting sector shaft
Fit sector shaft using seal saver LRT-57-021.
70.
Align roller with cut out in casing as shown. Push
in sector shaft while rotating input shaft to allow
sector roller to engage worm.
62.
63.
64.
Loosely screw adjuster into casing.
Fit locknut, do not tighten.
Turn in worm adjuster until end float is almost
eliminated. Ensure bearing cages are seated
correctly.
65.
66.
Measure maximum rolling torque of valve and
worm assembly, using a torque wrench and
spline socket LRT-57-025.
Turn in worm adjuster while rotating shaft to
increase figure measured to 0.56 Nm.
Fitting rack adjuster
71.
72.
Fit rack adjuster and thrust pad to engage rack.
Back off half turn on adjuster.
Loosely fit new nylon pad and adjuster set screw
assembly.
6
OVERHAUL
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field