1996 Land Rover Defender Worshop Manual 300 Tdi

FUEL SYSTEM
THROTTLE CABLE
Adjust
EGR THROTTLE POSITION SENSOR
Check
1.
Run engine until normal operating temperature is
reached.
1.
2.
3.
Slacken throttle cable adjustment ferrule.
Hold throttle lever in fully closed position.
Adjust outer cable, by rotating ferrule, to give
2.  Switch off engine and disconnect throttle position
sensor multi-plug.
1,57
mm (1/16 in) of deflection in the inner cable.
4.
Check that throttle opens fully when the throttle
is depressed.
3.  Connect an Ohmmeter across pins 1 and 3 of
multi-plug. Ohmmeter should read between 1K
and 1.05K ohms.
4.
Connect Ohmmeter across pins 1 and 2 of
multi-plug. Ohmmeter should read between 850
and 900 ohms.
5.
6.
If readings are correct, reconnect multi-plug.
If readings are not obtained slacken 2 torx
screws securing sensor.
7.
Rotate sensor to obtain correct Ohmmeter
reading, then tighten torx screws.
8.
9.
Re-check readings and fit multiplug.
If, after adjustment, Ohmmeter readings cannot
be achieved, fit new sensor. See Repair,  EGR
throttle position sensor
ADJUSTMENT
1
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field