33
CLUTCH
MASTER CYLINDER
8. Remove 6 screws and detach pedal box top
cover and gasket.
Service repair no - 33.20.01/03
9. Remove nut and washer securing master
cylinder push rod to clutch pedal trunnion.
10. Remove 2 nuts and bolts and withdraw master
cylinder from pedal bracket.
NOTE: All hose and pipe connections and
joints should be tightened to 15 Nm (11
lbf/ft).
Refit
Remove
11.
Fit master cylinder to pedal bracket, engaging
cylinder push rod through pedal trunnion.
1.
2.
Drain hydraulic fluid from system.
Disconnect fluid pipe at master cylinder. Plug
master cylinder fluid port and seal end of
hydraulic pipe to prevent ingress of dirt.
On RH drive vehicles, unclip air cleaner retaining
straps, disconnect bottom hose, and move
assembly aside.
12. Secure push rod to pedal trunnion.
13. Apply sealant to mating surfaces and fit pedal
bracket to engine bulkhead.
14. Connect fluid pipe to master cylinder.
15. Bleed clutch hydraulic system See Bleed
hydraulic system .
16. Check and adjust clutch pedal and master
cylinder setting See Adjustment, Clutch pedal
and master cylinder setting .
3.
4.
From inside vehicle, remove fibre board closing
panel above pedals.
17.
18.
Fit top cover and gasket to pedal bracket.
On RH drive vehicles, refit air cleaner.
5.
6.
7.
Remove 6 bolts securing pedal bracket to
bulkhead.
Remove screw securing speedometer cable
retaining bracket to top of pedal bracket.
Move pipework and cables aside and lift out
pedal bracket, complete with master cylinder,
turn through 90° to ensure pedal clears aperture
in bulkhead.
2
REPAIR
| Categories | Land Rover, Land Rover Defender |
|---|---|
| Tags | Land Rover |
| Model Year | 1996 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Defender 300 Tdi |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)