1996 Land Rover Defender Worshop Manual 300 Tdi

MANUAL GEARBOX
GEAR CHANGE LEVER BIAS SPRING - ADJUST
Service repair no - 37.16.26
1.
2.
3.
4.
Remove gear lever and transfer box lever knobs.
Remove gear lever cover.
Remove nut and washer securing gear lever.
Mark gear lever spline setting, remove lever and
gaiter from lower lever.
5.
6.
7.
8.
Remove insulation pad from tunnel aperture.
Fit gear lever and select 3rd or 4th gear.
Slacken adjustment screw locknuts.
Adjust screws until both legs of bias springs are
approximately 0.5mm clear of gear lever cross
pin.
9.
Apply a slight load to gear lever in a LH direction
and adjust RH screw downward until RH spring
leg just makes contact with cross pin.
Repeat procedure for LH adjustment screw.
Lower both adjustment screws equal amounts
until radial play is eliminated.
14.
15.
16.
17.
Remove gear lever.
Fit insulation pad.
Locate gaiter over lower lever and bias springs.
Fit gear lever to lower lever spline, secure with
new nyloc nut and tighten to 25 Nm (18 lbf/ft).
Fit gear lever cover.
10.
11.
18.
19.
12.
13.
Tighten locknuts.
Fit gear lever and transfer box lever knobs.
Return gear lever to neutral position and rock
across gate several times. The gear lever should
return to 3rd and 4th gate.
ADJUSTMENT
1
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field