WIPERS AND WASHERS
WIPER MOTOR
11. Withdraw yoke and armature.
12.
Remove brush gear assembly.
Service repair no - 84.15.18.
Dismantle
13. Remove limit switch.
Inspection and test
1.
Remove wiper motor from vehicle See Repair,
Wiper motor and drive rack.
Remove wiper motor gearbox cover.
Remove circlip and plain washer securing
connecting rod.
Withdraw connecting rod.
Withdraw flat washer.
Remove circlip and washer securing shaft and
gear.
Clean any burrs from gear shaft and withdraw
gear.
14. Check brushes for excessive wear, if they are
worn to 4,8 mm in length, fit a new brush gear
assembly.
15. Using a push type gauge, check that brush
spring pressure is 140 to 200 g when bottom of
brush is level with bottom of slot in brush box. Fit
a new brush gear assembly if springs are not
satisfactory.
2.
3.
4.
5.
6.
16. Test armature for insulation and open- or
short-circuits. Use a 110 V 15 W test lamp. Fit a
new armature if faulty.
7.
8.
9.
Withdraw dished washer.
Add alignment marks to yoke and gearbox for
reassembly.
17. Examine gear wheel for damage or excessive
wear.
10.
Remove yoke securing bolts.
Key to wiper motor components
1.
2.
3.
4.
5.
6.
7.
Flexible drive
Gearbox cover
Connecting-rod retaining washer and circlip
Connecting-rod
Flat washer
8. Dished washer
9. Alignment marks - yoke to body
10. Yoke securing bolts
11. Armature and yoke
12. Brush gear assembly
13. Limit switch
Gear shaft retaining washer and circlip
Drive gear
OVERHAUL
1
Product Specification
Categories | Land Rover, Land Rover Defender |
---|---|
Tags | Land Rover |
Model Year | 1996 |
Download File |
|
Document Type | Workshop Manual |
Language | English |
Product Name | Defender 300 Tdi |
Product Brand | Land Rover |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |