1996 Land Rover Defender Worshop Manual 300 Tdi

60
FRONT SUSPENSION
BUMP STOP
ANTI-ROLL BAR
Service repair no - 60.10.01
Remove
Service repair no - 60.30.10.
Remove
1.
2.
Mark for reassembly position of rubber bushes
on anti-roll bar.
Remove 4 nuts, bolts and washers securing both
anti-roll bar bush straps to chassis mounting
brackets.
1.
2.
Remove fixings.
Remove bump stop.
NOTE: A chassis undertray may be fitted
on some vehicle derivatives to conform to
legal requirements. When under chassis
remove and refit procedures are required, it may
be necessary to remove the undertray See
CHASSIS AND BODY, Repair, Front undertray .
Refit
3.
4.
Position bolts in slots in chassis brackets.
Fit bump stop, secure with washers and nuts.
3.
4.
Remove nuts, bolts, washers and rubber bushes
securing anti-roll bar to both links
Remove anti-roll bar.
Refit
5.
Position bushes on anti-roll bar. Ensure split
points towards axle on RH bush and away from
axle on LH bush.
6.
7.
8.
Fit anti-roll bar with two straps. To ensure correct
fit angled sides of bar should point down.
Loosely fit the bolts, washers and nyloc nuts.
Fit bolt, washers and rubber bushes. Using new
nuts fit anti-roll bar to links and tighten to 68Nm
(50
lbf/ft).
Tighten nuts securing straps to 30Nm (22lbf/ft).
4
REPAIR
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field