1996 Land Rover Defender Worshop Manual 300 Tdi

86
ELECTRICAL
HANDSET BATTERY
Service repair no - 86.77.13
Remove
Refit
7.  Fit new battery into handset retaining clip with
positive side uppermost. Finger marks will
adversely affect battery life; if possible, avoid
touching flat surfaces of battery and wipe clean
before fitting.
1.
2.
3.
Unlock vehicle and disarm alarm system.
Turn starter switch to position ’II’.
Turn starter switch back to position ’0’ and
remove key.
8.  Reassemble two halves of handset.
9.  Press RH (Padlock) button at least four times
within range of vehicle to resynchronise handset.
10.
Check operation of alarm system.
WARNING: The handset contains delicate
electronic circuits and must be protected
from impact and water damage, high
temperatures and humidity, direct sunlight and
effects of solvents, waxes and abrasive cleaners.
NOTE: New handsets must be be
initialised using TestBook.
4.
Carefully prise handset apart, starting from
keyring end, using a coin or small screwdriver.
Slide battery out from retaining clip.
Press and hold one of the handset buttons for at
least five seconds to drain any residual power
from handset.
5.
6.
NOTE: The engine will immobilise five
minutes after key is removed from starter
switch.
4
REPAIR
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field