86
ELECTRICAL
REVERSE LAMP SWITCH
Service repair no - 37.27.01
Remove
WARNING LAMP ASSEMBLY
Service repair no - 86.45.60 - Warning lamp
assembly
Service repair no - 86.45.61 - Warning lamp bulb
renewal
The reverse lamp switch is located on the LH side of
the gearbox extension housing and is accessible from
underneath the vehicle.
Remove
1.
Disconnect battery.
1.
Place vehicle on suitable ramp.
2.
3.
Disconnect reverse lamp switch lead multi-plug
from harness connector.
Unscrew switch from extension housing.
Refit
4.
Fit new switch to gearbox extension housing.
Tighten to 25 Nm (18 lbf/ft).
5.
Fit lamp switch lead multi-plug to harness
connector.
6.
Check operation of lamp switch.
2.
3.
Remove 2 screws and withdraw warning light
assembly from instrument panel.
Remove multi-plug to give access to warning
lamp bulbs.
4.
5.
Twist bulb holder and pull it from its socket.
Pull bulb from holder.
Refit
6.
7.
8.
9.
Fit new bulb and refit holder.
Fit multi-plug.
Fit warning lamp assembly to instrument panel
Reconnect battery.
18
REPAIR
| Categories | Land Rover, Land Rover Defender |
|---|---|
| Tags | Land Rover |
| Model Year | 1996 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Defender 300 Tdi |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)