1996 Land Rover Defender Worshop Manual 300 Tdi

12
ENGINE
CAMSHAFT OIL SEAL
Service repair no - 12.13.05
Remove
INJECTION PUMP GEAR
Service repair no - 19.30.06
Remove
1.
Remove camshaft gear.  See Camshaft gear
1.  Remove camshaft drive belt.  See Camshaft
drive belt
2.
Remove camshaft oil seal from front cover using
special tool LRT-12-083.
2.  Slacken 3 bolts on front of injector pump gear.
3.
4.
Remove special tool pin from gear.
Remove 3 bolts and withdraw gear and retaining
plate.
Refit
CAUTION: It is important to ensure that
when the injection pump is locked no
attempt must be made to rotate it. Take
care not to allow the crankshaft to be turned.
5.
6.
Fit gear and retaining plate. Tighten bolts to 25
Nm (18 lbf/ft).
Insert pin from special tool LRT-12-045 in
injection pump gear and through into pump
flange.
7.
Fit camshaft drive belt. See  Camshaft drive
belt
Refit
3.
Lubricate a new camshaft oil seal with clean
engine oil.
4.
With lip side leading, drive in seal squarely using
special tool LRT-12-082.
5.
Fit camshaft gear.  See Camshaft gear
12
REPAIR
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field