82
AIR CONDITIONING
HEATER MATRIX - LH DRIVE
Service repair no - 82.25.19
Remove
BLOWER MOTOR ASSEMBLY- LH DRIVE
Service repair no - 82.25.14
Remove
1.
Remove evaporator See Evaporator.
1. Remove heater/cooler unit See Heater/cooler
unit.
2.
Leaving evaporator in place, remove single
screw securing heater matrix pipe plate to base
of support frame.
3.
Refit
4.
Remove heater matrix and insulation pad.
Position insulation pad and fit heater matrix to
support frame.
5.
Fit heater matrix and evaporator assembly See
Evaporator.
2.
3.
4.
Remove 7 screws securing outlet duct to
heater/cooler unit.
Carefully break sealing compound around edge
of duct and pull ducting from unit.
Remove 15 screws located around cover seam.
Break sealing compound from unit body and top
cover.
5.
6.
Remove 4 screws and 4 nuts from top of cover.
From front of unit remove 2 screws adjacent to
low pressure pipe moulding.
7.
8.
At side of unit remove 2 screws adjacent to air
intake aperture.
Lift off top cover, release grommet and feed
blower motor wiring and air control flap rod
through respective apertures. Note thermostat
probe which is inserted in evaporator matrix
through top cover.
10
REPAIR
Product Specification
Categories | Land Rover, Land Rover Defender |
---|---|
Tags | Land Rover |
Model Year | 1996 |
Download File |
|
Document Type | Workshop Manual |
Language | English |
Product Name | Defender 300 Tdi |
Product Brand | Land Rover |
Document File Type | |
Publisher | landrover.com |
Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
Copyright | Attribution Non-commercial |