57
STEERING
POWER STEERING SYSTEM - TEST
Procedure
NOTE: If steering lacks power assistance.
Check pressure of hydraulic pump before
fitting new components. Use fault
1. A hydraulic pressure gauge and test adaptor is
used to test power steering system. This gauge
2
is able to measure 140 kgf/cm . The maximum
diagnosis chart to assist in tracing faults.
power steering system pressure is 77 kgf/cm .
2
Under certain fault conditions of the hydraulic
2.
pump it is possible to obtain pressures up to 105
. It is important to realise that pressure on
kgf/cm
2
gauge is same pressure being exerted upon
steering wheel. When testing, turn steering
wheel gradually while reading pressure gauge.
Check and maintain maximum fluid level of
reservoir.
Examine power steering units and connections
for leaks. All leaks must be rectified before
attempting to test the system.
3.
4.
5.
6.
Check steering pump drive belt tension and
renew belt if necessary, See ELECTRICAL,
Repair, Auxiliary drive Belt .
Assemble test equipment and fit to vehicle, as
shown in RR3959M.
7.
8.
Open tap of adaptor.
Bleed system, take care not to overload
pressure gauge.
9.
With system in good condition, pressures should
be:
(A) Steering wheel held on full lock and engine
running at 1,000 rev/min, 70 to 77 kgf/cm
(B) Steering wheel held on full lock and engine
idling, 28 kgf/cm
2
.
2
.
Checks should be carried out on both full lock
positions.
A. Steering box.
B. Steering pump.
C. Existing hose, steering box to pump.
D. Hose LRT-57-030.
CAUTION: Do not maintain this pressure
for more than 30 seconds in any one
minute to avoid overheating fluid and
possibly damaging seals.
E. Test adaptor LRT-57-001.
F. Pressure gauge LRT-57-005.
G. Thread adaptor LRT-57-004.
H. Thread adaptor LRT-57-022.
10. Release steering wheel and with engine idling.
Pressure should read below 7 kgf/cm .
2
11. If pressures differ to those given a fault exists.
12.
13.
14.
To determine if fault is steering box or pump.
Close adaptor tap for a maximum five seconds.
If gauge does not register specified pressure,
pump is faulty.
Fit a new pump, bleed system and repeat test. If
low pressure or a substantial imbalance exists,
fault is in steering box valve and worm
assembly.
2
FAULT DIAGNOSIS
| Categories | Land Rover, Land Rover Defender |
|---|---|
| Tags | Land Rover |
| Model Year | 1996 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Defender 300 Tdi |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)