GENERAL SPECIFICATION DATA
300Tdi
ENGINE
Type ................................................................................. Direct injection, turbocharged, intercooled
Number of cylinders ......................................................... 4
Bore ................................................................................. 90,47 mm
Stroke............................................................................... 97,00 mm
Capacity ........................................................................... 2495 cc
Compression ratio ............................................................ 19.5:1 ± 0.5:1
Valve operation ................................................................ O.H.V. pushrod operated
Crankshaft
Main bearing journal diameter.......................................... 63,475 - 63,487 mm
Regrind dimensions ......................................................... 63,233 - 63,246 mm
Crankpin journal diameter ................................................ 58,725 - 58,744 mm
Regrind dimensions ......................................................... 58,471 - 58,490 mm
Crankshaft end thrust ....................................................... Taken on thrust washers at centre main bearing
Crankshaft end float ......................................................... 0,05 - 0,15 mm
Main bearings
Number and type.............................................................. 5 halved shells with oil grooves
Diametrical clearance....................................................... 0,0792 - 0,0307 mm
Connecting rods
Length between centres ................................................... 175,38 - 175,43 mm
Diametrical clearance (big-end bearings) ........................ 0,025 - 0,075 mm
End float on crankpin ....................................................... 0,15 - 0,356 mm
Pistons
Type ................................................................................. Aluminium alloy, combustion chamber in crown.
Graphite coating on sidewalls.
Skirt diametrical clearance (at r/angle to gudgeon pin) .... 0,025 - 0,05 mm
Maximum height above combustion face ......................... 0,8 mm
Gudgeon pins
Type ................................................................................. Fuly floating
Fit in piston ....................................................................... Hand push fit
Diameter .......................................................................... 30,156 - 30,163 mm
Clearance in connecting rod ............................................ 0,003 - 0,016 mm
Piston rings
Type:
-
-
-
Top........................................................................ Barrel edge, chrome plated
Second.................................................................. Taper faced
Oil control .............................................................. Expander and rails
Gap in bore:
-
-
-
Top........................................................................ 0,40 - 0,60 mm
Second.................................................................. 0,30 - 0,50 mm
Oil control .............................................................. 0,30 - 0,60 mm
Clearance in piston grooves:
-
-
Second.................................................................. 0,050 - 0,085 mm
Oil control .............................................................. 0,050 - 0,085 mm
INFORMATION
1
| Categories | Land Rover, Land Rover Defender |
|---|---|
| Tags | Land Rover |
| Model Year | 1996 |
| Download File |
|
| Document Type | Workshop Manual |
| Language | English |
| Product Name | Defender 300 Tdi |
| Product Brand | Land Rover |
| Document File Type | |
| Publisher | landrover.com |
| Wikipedia's Page | http://en.wikipedia.org/wiki/Land_Rover |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)