1996 Land Rover Defender Worshop Manual 300 Tdi

PROPELLER SHAFTS
PROPELLER SHAFT
Service repair no - 47.15.02/03
Remove
1.
Place vehicle on ramp.
CAUTION: To ensure correct assembly
and reduce possibility of imbalance, mark
position of spider pin lubricator relative to
journal yoke ears, before removing propeller shaft
joint.
2.
3.
Mark drive flanges at each end of propeller shaft
for reassembly.
Remove 4 bolts/nuts from each end and remove
propeller shaft.
NOTE: A chassis undertray may be fitted
on some vehicle derivatives to conform to
legal requirements. When under chassis
remove and refit procedures are required, it may
be necessary to remove the undertray See
CHASSIS AND BODY, Repair, Front undertray or
See CHASSIS AND BODY, Repair, Rear undertray
.
Service repair no - 47.15.11/12
Overhaul
6.
7.
8.
9.
Remove circlips, and grease nipple.
Tap yokes to eject bearing cups.
Remove bearing cups and spider.
Repeat instructions 4 to 7 for opposite end of
propeller shaft if necessary.
4.
5.
Thoroughly examine universal joint for signs of
damage or wear. Replace if necessary.
Clean universal joint bearing cups and circlips.
10.
Clean yokes and bearing cup locations.
REPAIR
1
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field