1996 Land Rover Defender Worshop Manual 300 Tdi

74
WHEELS AND TYRES
WHEELS
Remove
8.  Tighten nuts as much as possible using a
suitable wrench.
9.  Lower vehicle and finally tighten nuts to correct
torque sequence shown.
WARNING: The parking brake acts on
transmission, not rear wheels, and may
not hold vehicle when jacking unless
Alloy wheels - 130 Nm (96 lbf/ft)
Steel wheels - 100 Nm (80 lbf/ft)
Heavy duty wheels - 170 Nm (125 lbf/ft)
following procedure is used. If one front wheel
and one rear wheel is raised no vehicle holding or
braking effect is possible. Wheels MUST be
chocked in all circumstances.
Apply parking brake, select a gear in main
gearbox and engage low gear in transfer box.
1.
2.
Loosen 5 wheel nuts.
Using a suitable trolley jack, raise vehicle and
place on axle stands  See INTRODUCTION,
Information,  Jacking .
3.
Remove wheel nuts and carefully withdraw
wheel over studs.
Refit
4.
5.
Ensure that retaining studs and nuts are clean.
Alloy wheels: Lightly coat wheel mounting spigot
face with a suitable anti-seize compound to
minimise possibility of adhesion between wheel
and spigot face.
6.
7.
Refit wheel taking care not to damage stud
threads. (Do not apply oil).
Fit wheel nuts and turn by hand for at least three
full threads before using any form of wheel
wrench.
6
REPAIR
REV: 09/97
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field