1996 Land Rover Defender Worshop Manual 300 Tdi

BRAKES
SERVO ASSEMBLY
Service repair no - 70.50.01
Remove
Refit
9.  Locate servo assembly and rubber washer to
engine bulkhead and secure to pedal box.
Tighten fixings to 14 Nm (10 lbf/ft).
10.
Fit brake pedal to servo push rod with clevis pin
and new split pin.
Before starting repair refer to general brake service
practice  See  General Brake Service Practice .
11.  Fit blanking grommets to each side of pedal box.
12.
At footwell, attach pedal return springs.
NOTE: The non-return valve and grommet,
are the only serviceable components. In
event of failure or damage, fit a new unit.
13.  Connect vacuum hose to servo non-return valve.
14.  Fit brake master cylinder to servo unit See
Master cylinder .
1.
2.
3.
4.
Remove master cylinder See Master cylinder .
Disconnect vacuum supply hose from servo unit.
At footwell, release 2 brake pedal return springs.
Disconnect leads from brake light switch at rear
of pedal box.
5.
6.
7.
8.
Remove blanking grommets from each side of
pedal box.
Remove split pin and clevis pin securing servo
push rod to brake pedal.
Remove 4 nuts and plain washers securing
servo to pedal box.
Remove servo assembly and rubber washer
from bulkhead.
REPAIR
5
Product Specification
CategoriesLand Rover, Land Rover Defender
Tags
Model Year1996
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 450 pages
Document TypeWorkshop Manual
LanguageEnglish
Product NameDefender 300 Tdi
Product BrandLand Rover
Document File TypePDF
Publisherlandrover.com
Wikipedia's Pagehttp://en.wikipedia.org/wiki/Land_Rover
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field