206
INSTRUMENT PANEL AND CONTROLS
NOTE: The factory defau lt zone is 8. During program -
ming, the zone valu e will wrap arou nd from zone 15 to
zone 1.
vehicle in one or more complete circles, at speed s und er
5 mph (8 km/ h), in an area free from power lines and
large metallic objects, until the “CAL” ind icator turns off.
The compass will now function norm ally.
Calibra ting the Compa ss (Mid Line Clust er Only)
ELECTRONIC VEHICLE INFORMATION CENTER
(EVIC) — IF EQUIPPED
If the compass appears erratic, inaccu rate, or abnorm al,
you may wish to calibrate it. However, prior to calibrat-
ing the compass, make sure the prop er Com pass Variance
valu e is selected .
The Electronic Vehicle Inform ation Center (EVIC) fea-
tures a driver-interactive display. It is located at the
bottom of the speed ometer in the instru ment cluster.
Vehicles equ ipped with steering wheel mounted buttons
(described in this section) are also equ ipped with the
EVIC. The EVIC consists of the follow ing:
NOTE: The vehicle speed must be at 0 mph (0 km/ h)
(manu al transm ission) or the gear selector lever in “P”
(Park) (auto transm ission) to enter the calibration mode.
To calibrate the compass, first, start the engine. Next,
press and hold the trip odometer button until the current
variance zone nu mber displays (approxim ately ten sec-
ond s). Then, press and hold the button again until the
direction displays with the “CAL” ind icator on continu -
ously (approxim ately ten second s). Finally, drive the
•
•
•
•
System Statu s
Vehicle inform ation warning message displays
Tire Pressu re Monitor System (If Equipped)
Personal Settings (Custom er Program mable Featu res)
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)