STARTING AND OPERATING
297
Preferred Procedure
With the engine RUNNING, slow the vehicle speed to
mph (3-5 km/ h).
Shift the transm ission into “N” (Neutral) (autom atic
2. With the ignition switch in the ON position, and the
engine OFF or RUNNING, shift the transm ission into
“N” (Neutral) (autom atic transm ission), or depress the
clutch pedal (manu al transm ission).
1.
2-3
2.
3.
Move the 4WD Control Switch to the desired position.
transm ission), or depress the clutch pedal (manu al trans-
mission).
4. After the desired position ind icator light is ON (not
flashing), shift the transm ission into gear (autom atic
mtransmission).ission), or release the clutch pedal (manu al trans- 5
3.
While still rolling, move the 4WD Control Switch to
the desired position.
4.
After the desired position ind icator light is ON (not
NOTE:
•
flashing), shift the transm ission into gear (autom atic
transm ission), or release the clutch pedal (manu al trans-
mission).
Steps 1 and 2 in the “Preferred Proced ure” and the
“Alternate Proced ure” are requ irem ents for shifting
the transfer case. If these requ irem ents are not met
prior to attem pting the shift or while the shift attem pt
is in process, then the ind icator light will flash, and the
current transfer case position will be maintained . To
retry a shift, move the 4WD Control Switch back to the
Alterna te Procedure
1.
Bring the vehicle to a complete stop .
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)