2008 Jeep Liberty Owners Manual

322
STARTING AND OPERATING
3.
4.
5.
6.
7.
switch  bank  below  the  climate control   four times  within
twenty   second s. The  “ESP/ TCS  Ind icator”  light  shou ld
turn  on  and  turn  off two  times.
Apply  the  parking  brake.
Start  the engine.
HDC (Hill Descent Control) –  If Equipped
HDC  is  only  intend ed  for  low  speed   off-road   driving.
HDC  maintains   vehicle  speed  while  descend  ing hills  in
off-road  driving  cond itions  by applying  the  brakes  when
necessary.
Release  the clutch  pedal   (manu al transm ission).
Rotate  the  steering  wheel   12 turn  to  the left.
When   enabled ,  HDC  senses   the  terrain    and  activates
when  the vehicle  is descend ing a hill.  HDC speed  may  be
adjusted   by the driver  to  suit the  driving  cond itions.  The
speed  corresp ond s to  the transm  ission  gear selected .
Press   the  “ESP  OFF”   button   located   in   the  lower
Gear
Approxim  ate HDC   Set Speed
1 mph  (1.5 km/  h)
8.
additional    12 turn  to  the  right.
Rotate  the  steering  wheel  back  to  center  and  then  an
1st
2nd
3 mph  (4.5 km/  h)
9.
Turn  the ignition   switch  to the  OFF position  and  then
D (Drive)
R (Reverse)
N (Neutral)
7.5 mph  (12 km/  h)
1 mph  (1.5 km/  h)
back  to the  ON position.   If the  sequ ence was  completed
prop erly, the  “ESP/  TCS Ind icator”  light  will  blink  sev-
eral  times  to confirm  HSA  is disabled .
3 mph  (4.5 km/  h)
However,   the   driver   can  overrid e  HDC   operation   by
applying   the  brake  to slow  the  vehicle  down  below   the
10.
to its  previou s setting.
Repeat  these  step s if you  want  to retu rn  this  featu re
Product Specification
CategoriesJeep Liberty Manuals, Jeep Manuals
Model Year2008
Download File
Please Enter the Security Characters Shown Below. Letters are Case Sensitive. Your download link will appear upon completing this step.
- 493 pages
Document File TypePDF
CopyrightAttribution Non-commercial
(0 votes, average: 0 out of 5)

Submit your review (optional)
(will not be displayed)
* Required Field