266
INSTRUMENT PANEL AND CONTROLS
NOTE:
Manual Operation
•
The tem peratu re setting can be adjusted at any time
withou t affecting autom atic operation.
This system offers a full complement of manu al overrid e
featu res, which consist of Blower Preferred Autom atic,
Mod e Preferred Autom atic, or Blower and Mod e Pre-
ferred Autom atic. This means the operator can overrid e
the blow er, the mode, or both. There is a manu al blow er
range for times when the AUTO setting is not desired .
The blow er can be set to any fixed blow er speed by
rotating the Blower Control knob (on the left).
•
Pressing the Air Cond itioning Control button while in
AUTO mode will cause the LED in the control button
to flash three times and then turn off. This ind icates
that the system is in AUTO mode and requ esting the
air cond itioning is not necessary.
•
If you r air cond itioning perform ance seem s lower than
expected , check the front of the A/ C cond enser: lo-
cated in front of the rad iator, for an accumulation of
dirt or insects. Clean with a gentle water spray from
behind the rad iator and throu gh the cond enser. Fabric
front fascia protectors may red uce airflow to the
cond enser, red ucing air cond itioning perform ance.
NOTE: Please read the Autom atic Temperatu re Control
Operation Chart that follow s for details.
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)