THINGS TO KNOW BEFORE STARTING YOUR VEHICLE
49
3.
Within 60 second s of turning the ignition switch to the
Automatic Locking Mode — If Equipped
ON position, unbu ckle and then re-bu ckle the driver’s
seat belt at least three times within 10 second s, end ing
with the seat belt buckled .
In this mode, the shou lder belt is autom atically pre-
locked . However, the belt will still retract to rem ove any
slack in the shou lder belt.
2
NOTE: Watch for the Seat Belt Remind er Light to turn
on while unbu ckling the seat belt and turn off while
re-bu ckling the seat belt. It may be necessary to retract
the seat belt.
When To Use The Autom atic Locking Mode
Anytim e a child safety seat is installed in the rear
outboard seating position. Child ren 12 years old and
und er shou ld be prop erly restrained in the rear seat
whenever possible.
4.
Turn the ignition switch to the LOCK position. A
single chim e will sou nd to signify that you have success-
fully completed the program ming.
How To Use The Autom atic Locking Mode
1.
Buckle the combination lap and shou lder belt.
The Enhanced Warning System (BeltAlert) can be reacti-
vated by rep eating this proced ure.
2.
the entire belt is extracted .
Grasp the shou lder portion and pull downw ard until
NOTE: When the Enhanced Warning System (BeltAlert)
is deactivated , the Seat Belt Remind er Light will continu e
to illuminate as long as the driver’s seat belt is unbu ck-
led.
3.
hear a clicking sou nd . This ind icates the safety belt is
now in the autom atic locking mode.
Allow the belt to retract. As the belt retracts, you will
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)