296
STARTING AND OPERATING
2WD to 4WD Lock
red uce speed and stop spinning the wheels to com-
plete the shift. There may be a delay up to 10 second s
for the shift to complete after the wheels have stop ped
spinning.
Move the 4WD Control Switch to the desired position.
Shifts betw een 2WD and 4WD LOCK can be done with
the vehicle stop ped or in motion. With the vehicle in
motion, the transfer case will engage / disengage faster if
you momentarily release the accelerator pedal after mov-
ing the 4WD Control Switch. If the vehicle is stop ped, the
ignition switch must be in the ON position with the
engine either OFF or RUNNING. This shift cannot be
completed if the ignition switch is in the ACC position.
•
Delayed shifting out of 4WD LOCK may be experi-
enced due to uneven tire wear, low tire pressu re, or
excessive load ing.
4WD Lock to 4WD Low
When shifting into or out of 4WD LOW, som e gear noise
may be heard . This noise is norm al and is not detrim ental
to the vehicle or its occupants
NOTE:
•
The 4-wheel drive system will not allow shifts be-
tween 2WD and 4WD LOCK if the rear wheels are
spinning (no traction). In this situ ation, the selected
position ind icator light will flash and the original
position ind icator light will rem ain ON. At this time,
Shifting can be perform ed with the vehicle rolling 2-3
mph (3-5 km/ h) using the “Preferred Proced ure” or
completely stop ped using the “Alternate Proced ure.”
| Categories | Jeep Liberty Manuals, Jeep Manuals |
|---|---|
| Model Year | 2008 |
| Download File |
|
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)