464
MAINTAINING YOUR VEHICLE
Fluid Level Check — 3.3L Engin e with Four-Sp eed
Autom atic Transaxle — If Equipped
The dipstick is located just behind the rad iator, lower
right side.
4. Place the gear selector lever momentarily in each gear
position end ing with the lever in PARK. Wipe the area
arou nd the dipstick clean to eliminate the possibility of
dirt entering the transaxle.
5.
Remove the dipstick and determ ine if the fluid is hot
or warm . Hot fluid is approxim ately 180°F (82°C), which
is the norm al operating tem peratu re after the vehicle has
been driven at least 15 miles (24 km). The fluid cannot be
comfortably held betw een the finger tips. Cold is when
the fluid is below 80°F (27°C).
To prop erly check the autom atic transaxle fluid level, the
follow ing proced ure must be used :
6.
Wipe the dipstick clean and reinsert until seated .
Remove dipstick and note read ing.
1.
The vehicle must be on level grou nd .
a. If the fluid is hot, the read ing shou ld be in the
crosshatched area marked “HOT” (betw een the upper
two holes in the dipstick).
2.
The engine shou ld be running at curb idle speed for a
minim um of 60 second s.
3.
Fully apply parking brake.
b. If the fluid is cold, the fluid level shou ld be betw een
the lower two holes in the area marked “COLD”.
Product Specification
Categories | Chrysler Manuals, Chrysler Town and Country Manuals |
---|---|
Model Year | 2008 |
Download File |
|
Document File Type | |
Copyright | Attribution Non-commercial |
Looked up a few items and was impressed with how fast it worked. Bought vehicle used and manual was missing. Thanks to this sight I can figure out all these buttons and switches.
good job ........excelent the explain .....