AN HMA 4A.QXP 3/5/2015 3:18 PM Page 73
Features of your vehicle
Programming
✽ NOTICE
Flashing
Some devices may require you to
replace this Programming step 3 with
procedures noted in the "Gate
Operator/Canadian Programming"
Flashing
section. If the HomeLink indicator
®
light does not change to a rapidly
blinking light after performing these
steps,
contact
HomeLink
®
at
www.homelink.com.
4.
Firmly press, hold for 5 seconds
and release the programmed
OYF042251N
2.
3.
Position the end of your hand-held
transmitter 1-3 inches (2-8 cm)
®
away from the HomeLink button
you wish to program while keeping
the indicator light in view.
Simultaneously press and hold
®
and hand-
held transmitter buttons until the
indicator light changes
OYF042252N
HomeLink button up to two sepa-
®
To train most devices, follow these
instructions:
For first-time programming, press
and hold the two outside buttons
Channel 1
rate times to activate the door. If the
door does not activate, press and
®
hold the just-trained HomeLink but-
ton and observe the indicator light.
• If the indicator light stays on con-
stantly, programming is complete
and your device should activate
when the HomeLink button is
®
pressed and released.
• If the indicator light blinks rapidly
for 2 seconds and then turns to a
constant light, continue with
"Programming" steps 5-7 to com-
plete the programming of a rolling
code equipped device (most com-
monly a garage door opener).
1.
(
,
), HomeLink
®
both the HomeLink
and Channel 3, until the indicator
light begins to flash (after 10 sec-
onds). Release both buttons. Do
not hold the buttons for longer
than 20 seconds.
HomeLink
®
from a slow to a rapid blinking
light. Now you may release both
and hand-held
the HomeLink
®
transmitter buttons.
4
73
| Categories | Hyundai Manuals, Hyundai Santa Fe Manuals |
|---|---|
| Download File |
|
| Document Type | Owners Manual |
| Language | English |
| Product Brand | Hyundai, Santa Fe |
| Document File Type | |
| Copyright | Attribution Non-commercial |
(0 votes, average: 0 out of 5)