AN HMA 4A.QXP 3/5/2015 3:18 PM Page 74
Features of your vehicle
At the garage door opener receiv- Gate operator & Canadian
Reprogramming a single
er (motor-head unit) in the garage,
locate the "learn" or "smart" but-
ton. This can usually be found
where the hanging antenna wire is
attached to the motor-head unit.
During programming, your handheld To program a device to HomeLink
transmitter may automatically stop using a HomeLink
transmitting. Continue to press the trained, follow these steps:
Firmly press and release the Control System button (note steps 2
"learn" or "smart" button. (The through 3 in the Programming por-
name and color of the button vary tion of this document) while you
by manufacturer). There are 30 press and re-press ("cycle") your
release the button.
indicator light will begin to flash
after 20 seconds. Without releasing
the HomeLink button, proceed
with "Programming" step 2.
seconds to initiate step 7.
Return to the vehicle and firmly
press, hold for 2 seconds and
handheld transmitter every two sec-
onds until the frequency signal has
been learned. The indicator light will
flash slowly and then rapidly after
button. Repeat the
several seconds upon successful For questions or comments, contact
HomeLink® at www.homelink.com or
"press/hold/release" sequence a
second time, and, depending on
the brand of the garage door Operating HomeLink
opener (or other rolling code
equipped device), repeat this
sequence a third time to complete
the programming process.
To operate, simply press and release
the programmed HomeLink
Activation will now occur for the
trained device (i.e. garage door
opener, gate operator, security sys-
tem, entry door lock, home/office
lighting, etc.). For convenience, the
hand-held transmitter of the device
may also be used at any time.
rolling code equipped device.
should now activate your
|Categories||Hyundai Manuals, Hyundai Santa Fe Manuals|
|Document Type||Owners Manual|
|Product Brand||Hyundai, Santa Fe|
|Document File Type|
(0 votes, average: 0 out of 5)